Our 20-foot ISO container unit is divided into two sections, one with three and the other with four shower cubicles, each with their own side entry doors allowing female and male showering at the same time with complete privacy. The communal changing area in each of the two sections contains a hand basin, mirror, built in seating, clothes hooks and non-skid flooring.

Gas Requirements

Hot water is heated by 3 continuous flow hot water heating units. These run off 2 x 45kg LP Gas bottles. Supply of the gas bottles to be discussed upon booking.

Power Requirements

A 240V, single phase power supply is required for the electrical pump, ignition source and lighting. The unit comes with a six-metre power lead with a normal 3 pin outlet and the unit has full RCD protection.

Water Requirements

The water required to feed the unit is 30 litres per minute at 350kpa. Waste water is discharged via a 50mm BSP outlet which has to be discharged in a Local Authority Bylaw approved manner e.g. gully trap, soak pit, manhole.

Transport

This unit is transported and handled by a truck with Hi-Ab crane or swing lift side loader. Pick up and return from one of our nationwide depots. Alternatively, Portashowers can arrange transport to and from your site as well as installation at an additional cost.

Installation

Detailed installation instructions are provided for the container unit prior to delivery or delivery. Installation for the container unit takes approximately 1 hour including testing of the operation.

Specifications
  • Height: 2.6 metres
  • Length: 6.0 metres
  • Width: 2.4 metre
  • Weight: s 2.8 tonnes

Our 20-foot ISO container unit is divided into two sections, one with three and the other with four shower cubicles. The communal changing area in each of the two sections contains a hand basin, mirror and built in seating. Hot water is heated by LP Gas and a 240V power supply is required for the electrical pump and lighting.

container